FITTING GUIDE
Follow these steps as a guide to fit your new plate...
30 Day warranty only applies when you use our fixings.
Fitting with sticky pads*:
1. Remove the old plate, clean the area where the new plate is to be fitted.
2. Apply adhesive pads to the plate, and remove the film from them.
3. Position the plate over desired location, ensuring it is straight and level.
4. Once in correct position press the plate down firmly, and the adhesive pads will stick.
5. Peel away the protective film from the plate.. And your all done!
* Some strong sticky pads such as 3M may react/cause damage to the plate, we will not warranty this. So we advise our sticky pads are used for warranty to be valid.
Fitting with screws/bolts see below**:
1. Remove the old plate, clean the area where the new plate is to be fitted.
2. Place the old number plate on top of your new one and use it as a guide to measure where the holes need to be drilled into the new plate.
3. Carefully drill through the holes and into your new plate with an appropriately sized drill bit.
4. We highly recommend putting sticky pads on the back of the plate where the screw holes are, this prevents any damage or water getting into the backing of the plate during vehicle use.
5. Fix the plate to your vehicle using the screws/bolts
6. Peel away the protective film from the plate.. And your all done!
** Do not over tighten your screws, nuts or bolts as this will damage your plate, we will not warranty this.
Curved panels/ Hanger brackets
If fitting Flexi Plates to a permanently curved surface like a curved hanger bracket or curved mudguard we highly recommend a vinyl stick on plate not a rigid plate.